Answer
Oct 05, 2026 - 08:19 AM
To replace the solenoid coil on a MAC Valve 800 Series pneumatic valve, follow this breakdown of safety steps, mechanical disassembly, and rewiring instructions.
Step 1: Pre-Service Safety
1. Lockout/Tagout (LOTO): Shut off and tag out the main electrical power supplying the valve stack.
2. Depressurize: Shut off the primary air supply line and cycle the valve manually (using the manual operator override) to vent all trapped compressed air. Never service a pressurized valve.
Step 2: Mechanical Disassembly
Step 2: Mechanical Disassembly
The MAC 800 Series features a modular, sealed solenoid enclosure. You do not need to remove the main valve body from the pipe line or air manifold to change the coil.
1. Access the wiring: Remove the electrical conduit cover or unplug the DIN/Deutsch connector if your specific model uses a plug-in connection.
2. Remove the retainer: Locate and unscrew the hex nut or central cap nut on top of the solenoid armature tower.
3. Slide off the coil: Pull the old coil straight up and off the central valve armature core post. Take note of any O-rings, washers, or grounding tabs beneath it.
Step 3: Install the New Coil
Note: Ensure your replacement coil matches the correct operating voltage (e.g., 12VDC, 24VDC, 120VAC) of your system.
1. Seat the coil: Slide the new coil down over the metal valve post. Ensure it is oriented in the direction needed for your wiring alignment.
2. Secure the nut: Reinstall the washer/O-ring and hand-tighten the retainer nut. Use a wrench to snug it down firmly, but do not overtighten, as doing so can crush the internal tube or cause the valve spool to bind.
Step 4: Electrical Connection
1. Connect the leads: If using standard lead wires, connect the two primary power wires using crimp connectors or wire nuts.
• For AC/DC Coils: Polarity generally does not matter for standard 2-wire coils unless they feature an integrated LED indicator.
2. Grounding: Always attach the green/yellow grounding wire to the ground terminal or housing if equipped.
3. Reassemble: Tuck the wires neatly back into the junction conduit and re-secure the sealed enclosure cover.
Step 5: Testing the System
1. Re-apply the main pneumatic air pressure supply slowly and listen closely for any leaks.
2. Turn the electrical power back on.
3. Test the valve by firing it programmatically or clicking the manual override to verify that the coil clicks loudly and shifts the pneumatic spool correctly.
